SWALES 3 IN 1

img_3692 swales Copper Ball Link hrc.jpg

About Swales 3 in 1

The Swales 3 in 1 with its curb chain and points of attachment for two sets of reins, is a Pelham bit.  Please see the Pelham category for more details. 

The top reins are attached to the loose sliding rings that are fitted around the bit’s mouthpiece. A curb chain is attached to the spiral section above the mouthpiece. While it is true to say that the poll pressure is greatly reduced because these inside rings slip around the mouthpiece, it is also important to acknowledge that they will have the ability to intensify the bit’s action by squeezing inwards upon the sides of lips and mouth. 

1/3

SP10: Copper Rollers Port Mouth Swales 3 in 1
Copper Rollers Port Mouth Swales 3 in 1
SP11: ST.ST. Swales 3 in 1
ST.ST. Swales 3 in 1
SP12: Swales Driving Bit
Swales Driving Bit
SP13: Swales Vulcanite Port 3 in 1wales%20Vulcanite%20Mouth%20
Swales Vulcanite Port 3 in 1
SP14: Swales Rubber Mullen 3 in
Swales Rubber Mullen 3 in 1
SP15: High Port Swales 3 in 1
High Port Swales 3 in 1
SP16: Swales 3 in 1 Fixed Cheek
Swales 3 in 1 Fixed Cheek
SP17: Swales 3 in 1 Copper Players
Swales 3 in 1 copper players
SP18: Swales 3 in 1 with Copper Ball
Swales 3 in 1 with Copper Ball
SP19: Swales 3 in 1 Fixed Port Copper Hanoverian
wales 3 in 1 Fixed Port Copper Hanoverian
Show More

Find What You’re Looking For

WHAT IF I REQUIRE A VARIATION WHICH ISN'T SHOW IN THE GALLERY?  

If you need a variation not shown on the product pages, we still may be able to make it,  so please don't hesitate to contact us using the contact us pages shown at the top of any page.

COMMON QUERIES

WHICH PAYMENT METHODS DO YOU ACCEPT?

We accept many of the major payment methods, such as; Visa, Mastarcard and recently PayPal. 

HOW ARE YOUR DRIVING BITS MEASURED?

The diagram on the right shows you how we measure our bits. We can make longer length cheeks if you have the need for more leverage. The bit width is especially important to get right. Don't forget we can do mouth piece sizes to the nearest 1/4" so you can be sure to get the right size.

©2021 by A Bit Special